Hi,
Does anyone know if you can have a 1-N configuration with a single rcip interface for each target array?
Another words if you have a source array with 2 rcip interfaces, can N:S:P 0:3:1 point to array2 and N:S:P 1:3:1 point to array3?
I was hoping this was possible but when I try and 'add to configuration ' and choose 1-N setup it does not allow me. This is a temp solution till we move data to new array.
Any help would be appreciated.
Thanks
remote copy - rcip
-
- Posts: 4
- Joined: Mon Dec 23, 2013 10:00 am
Re: remote copy - rcip
No you can't. From the documentation:
"Primary arrays with only two controller nodes must use 2 IP and 2 FC links." So you could do an asynchronous\synchronous setup if one of your array pairs were close enough that you could use RCFC for one pair.
"Primary arrays with only two controller nodes must use 2 IP and 2 FC links." So you could do an asynchronous\synchronous setup if one of your array pairs were close enough that you could use RCFC for one pair.