HPE Storage Users Group

Hi,

Having issues setting up the RC links between 2 arrays

If I run the following on the new array ' admitrcopylink target_array 0:3:1:1.1.1.1 '

where target_array is the other side
0:3:1 is local NSP
1.1.1.1 is target IP

I get 'Could not find taregt xxxx'

The ports can PING each other via the gui

If try with IP of target array I also get same message. Anyone else had this issue?

Thanks

Are you confident that the basics have been done ok?

All interfaces have an IP address?
Any required routing done?
rcopy started?

if this is the first set of links you can do it with creatercopytarget command

Have you tried 'drag & drop' in the GUI?

Hi, I have just realised that with 3.1.2 you cannot do 1-N which is what I was trying. Instead I will have to break existing config - or at least 1 port then move stuff across to new array.

Thanks