Page 1 of 1

3par error from SSH in response to any command

Posted: Sat Jul 10, 2021 1:56 pm
by Hector
Hello

I have an error appear at the SSH for one of our storage system 3PAR 7400

in response to almost any command says " showsys: Error: Could not find request handler: EAIPC_NOPHANDLE --no phandle is available or found "

Image

I appreciate if you give me any ideas about this problem.
Thanks.

Re: 3par error from SSH in response to any command

Posted: Tue Jul 13, 2021 1:57 am
by MammaGutt
Considering you can't get any decent output from "showsysmgr" I would log a case with HPE.

You might need to reboot a node, you might need to reboot the system and you could possibly get into a worse state by doing one of the options above...

What 3PAR OS version are you running?

Re: 3par error from SSH in response to any command

Posted: Tue Jul 13, 2021 6:29 am
by Hector
MammaGutt wrote:Considering you can't get any decent output from "showsysmgr" I would log a case with HPE.

You might need to reboot a node, you might need to reboot the system and you could possibly get into a worse state by doing one of the options above...

What 3PAR OS version are you running?


Many thanks for your help, 3PAR OS version is 3.2.2 MU4

I had tried to reboot a node but CLI reject that command too. my network connectivity is ok and I can SSH to 3PAR but SSMC and SP disconnected and can't established a connection.

Thanks.

Re: 3par error from SSH in response to any command

Posted: Tue Jul 13, 2021 9:28 am
by MammaGutt
Hector wrote:
MammaGutt wrote:Considering you can't get any decent output from "showsysmgr" I would log a case with HPE.

You might need to reboot a node, you might need to reboot the system and you could possibly get into a worse state by doing one of the options above...

What 3PAR OS version are you running?


Many thanks for your help, 3PAR OS version is 3.2.2 MU4

I had tried to reboot a node but CLI reject that command too. my network connectivity is ok and I can SSH to 3PAR but SSMC and SP disconnected and can't established a connection.

Thanks.


Yeah, support case is probably the way to go. MU4 has been inactive for a couple of years so probably not a bad idea to get an OS upgrade done as well to MU6 which will be active for as long as the 7000 series is supported.

Re: 3par error from SSH in response to any command

Posted: Tue Jul 13, 2021 10:34 am
by Hector
Currently SP disconnected and can't established a connection for OS upgrade.
Thanks