Page 1 of 1

Multiple Host Objects for the same physical host?

Posted: Wed Nov 26, 2014 4:15 pm
by brendon
Hey there,

I cannot find any documentation for this scenario and wanted to double check. Basically, we have a host with 6 HBAs configured. 2 for Boot, 2 for Production Data, and 2 will be taken by Hyper-V for Direct SAN to the VMs. In the 3Par Management Console, if we wanted to separate the traffic from boot and production, would I create separate hosts for each HBA set? In this case it would look like:

Host1Boot (011, 111, 012, 112)*
Host1Prod (211, 311, 313, 312)*
* For Persistent Ports

Or does 3Par not support that and would rather have all traffic coming from one set of HBAs touching all nodes?

Re: Multiple Host Objects for the same physical host?

Posted: Wed Nov 26, 2014 5:59 pm
by afidel
Why on gods green earth would you spend ~$2000 per host for dedicated boot hba's? All you need to do is assign the boot volume as lun 1 on the production HBA.

Re: Multiple Host Objects for the same physical host?

Posted: Wed Nov 26, 2014 6:21 pm
by Davidkn
There is absolutely no reason to have this setup, so I dount its documented anywhere.

Should work as you've put though, but I honestly can't see the point.