HPE Storage Users Group https://3parug.net/ |
|
remote copy - rcip https://3parug.net/viewtopic.php?f=18&t=632 |
Page 1 of 1 |
Author: | 3padm [ Mon Mar 10, 2014 4:27 pm ] |
Post subject: | remote copy - rcip |
Hi, Does anyone know if you can have a 1-N configuration with a single rcip interface for each target array? Another words if you have a source array with 2 rcip interfaces, can N:S:P 0:3:1 point to array2 and N:S:P 1:3:1 point to array3? I was hoping this was possible but when I try and 'add to configuration ' and choose 1-N setup it does not allow me. This is a temp solution till we move data to new array. Any help would be appreciated. Thanks |
Author: | storageguy [ Fri Mar 21, 2014 10:21 am ] |
Post subject: | Re: remote copy - rcip |
No you can't. From the documentation: "Primary arrays with only two controller nodes must use 2 IP and 2 FC links." So you could do an asynchronous\synchronous setup if one of your array pairs were close enough that you could use RCFC for one pair. |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |