| HPE Storage Users Group https://3parug.net/ |
|
| change Storserv Time https://3parug.net/viewtopic.php?f=18&t=568 |
Page 1 of 1 |
| Author: | chanchon [ Sat Feb 01, 2014 2:25 am ] |
| Post subject: | change Storserv Time |
recently i found that the time on inform os (Storserv - 3.1.2 Mu2) is not correct . i wanted to change it and make it right . how should i do that ? my system is up and serviceing. may it be cause problem or any downtime ? thanks |
|
| Author: | steve_carlose [ Sun Feb 02, 2014 10:06 am ] |
| Post subject: | Re: change Storserv Time |
Hi you have to connect to the mgm port in controller with console user and cmp43pd password. then you will be able change it |
|
| Author: | Gakecs [ Tue Feb 04, 2014 3:58 pm ] |
| Post subject: | Re: change Storserv Time |
chanchon... had this same problem today... about 2 weeks after retiring my old PDCe and standing up the new 2012R2 one. In the SPOCC i was unable to figure out what was going on... since I had no NTP server setup. I ended up entering the inForm CLI, sending the "showdate" command to check the time on both my nodes, and then "setnet ntp xxx.xxx.xxx.xxx" where the X's are your IPv4 address obviously. After that, Node 0 syncd correctly, and about 5 minutes later Node 1 had the correct time as well. I'm using a 3PAR 7200 2-Node by the way. |
|
| Author: | Richard Siemers [ Wed Feb 05, 2014 10:38 am ] |
| Post subject: | Re: change Storserv Time |
Gakecs wrote: chanchon... had this same problem today... about 2 weeks after retiring my old PDCe and standing up the new 2012R2 one. In the SPOCC i was unable to figure out what was going on... since I had no NTP server setup. I ended up entering the inForm CLI, sending the "showdate" command to check the time on both my nodes, and then "setnet ntp xxx.xxx.xxx.xxx" where the X's are your IPv4 address obviously. After that, Node 0 syncd correctly, and about 5 minutes later Node 1 had the correct time as well. I'm using a 3PAR 7200 2-Node by the way. I can confirm that these are the commands I used to config my environment as well. With AD authentication enabled on the Inserv, its important to keep time synced, if you drift to far out of sync with the DC, then you can't us AD authentication any more. |
|
| Author: | spencer.ryan [ Tue Feb 11, 2014 3:07 pm ] |
| Post subject: | Re: change Storserv Time |
For reference Kerberos tickets have a default max skew of 5 minutes. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|