| HPE Storage Users Group https://3parug.net/ |
|
| remote copy setup https://3parug.net/viewtopic.php?f=18&t=554 |
Page 1 of 1 |
| Author: | 3padm [ Wed Jan 22, 2014 12:47 pm ] |
| Post subject: | remote copy setup |
Hi, Having issues setting up the RC links between 2 arrays If I run the following on the new array ' admitrcopylink target_array 0:3:1:1.1.1.1 ' where target_array is the other side 0:3:1 is local NSP 1.1.1.1 is target IP I get 'Could not find taregt xxxx' The ports can PING each other via the gui If try with IP of target array I also get same message. Anyone else had this issue? Thanks |
|
| Author: | TinDog [ Thu Jan 23, 2014 12:21 pm ] |
| Post subject: | Re: remote copy setup |
Are you confident that the basics have been done ok? All interfaces have an IP address? Any required routing done? rcopy started? if this is the first set of links you can do it with creatercopytarget command Have you tried 'drag & drop' in the GUI? |
|
| Author: | 3padm [ Fri Jan 24, 2014 8:24 am ] |
| Post subject: | Re: remote copy setup |
Hi, I have just realised that with 3.1.2 you cannot do 1-N which is what I was trying. Instead I will have to break existing config - or at least 1 port then move stuff across to new array. Thanks |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|