| HPE Storage Users Group https://3parug.net/ |
|
| Receive Error count on management interfaces https://3parug.net/viewtopic.php?f=18&t=526 |
Page 1 of 1 |
| Author: | Patrick [ Thu Jan 02, 2014 12:14 pm ] |
| Post subject: | Receive Error count on management interfaces |
I've an an on-again off-again revolving ticket issue with HP support over the last few months. The below error message appears across varying management interfaces on a 7400 and on a 7200. It seems as if HP support is stumped by the issue, thoughts? State : New Message Code: 0x0260001 Repeat Count: Occurred 6 times, first at 2013-12-18 19:26:13 CST Time : 2013-12-27 01:23:28 CST Severity : Informational Type : Ethernet Monitor Event Component : hw_node:0,hw_eth:0 Message : Node 0 eth0 Ethernet device error detected- Receive Error count increased by (2) (200%)- Receive Frame Error count increased by (2) (200%) Id : 76 State : New Message Code: 0x0260001 Repeat Count: Occurred 19 times, first at 2013-12-20 06:33:10 CST Time : 2013-12-26 04:31:27 CST Severity : Informational Type : Ethernet Monitor Event Component : hw_node:1,hw_eth:0 Message : Node 1 eth0 Ethernet device error detected- Receive Error count increased by (2) (200%)- Receive Frame Error count increased by (2) (200%) |
|
| Author: | Richard Siemers [ Tue Jan 07, 2014 10:59 am ] |
| Post subject: | Re: Receive Error count on management interfaces |
What type of switch are they connected to? Generic suggestion, you might want to hard code the speed and duplex settings for the switch port. |
|
| Author: | Patrick [ Thu Jan 09, 2014 7:30 pm ] |
| Post subject: | Re: Receive Error count on management interfaces |
They are connected to a couple of 5406zl's via the 20-port gig copper modules. Didn't see any frame alignment errors or port flapping so didn't think it was a duplex issue, but will try hard-coding the node on site. |
|
| Author: | hdtvguy [ Fri Jan 10, 2014 12:04 pm ] |
| Post subject: | Re: Receive Error count on management interfaces |
Hmm, reminds me of the issues we had on our V400. We found back in 3.1.1 there were issues which believe it not 3par said were compatibility issues with certain Cisco switches and code level. We always called bunk on that, but the way we resolved isse was to set all the management ports to 100mb at the switch and on the array. Issues went away. I was told those port issues were fixed a while back and was getting ready to move my ports back to AUTO (1gb), but now you have be nervous 
|
|
| Author: | Richard Siemers [ Tue Jan 14, 2014 12:05 pm ] |
| Post subject: | Re: Receive Error count on management interfaces |
I have similar issues on my Cisco MDS9148 SAN switch management ports connecting to Cisco NX5000 switches... Cisco can't even auto-negotiate with itself correctly at times. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|