HPE Storage Users Group
https://3parug.net/

Controller Node 7200 blinking amber and blue
https://3parug.net/viewtopic.php?f=18&t=3566
Page 1 of 1

Author:  tordy [ Fri Apr 30, 2021 9:53 am ]
Post subject:  Controller Node 7200 blinking amber and blue

we have a 3par 7200 with 2 nodes .
one node has failed and is now flashing amber and blue.

no error is detected via the CLI.
What can I do ? Is the node broken ?

Author:  koopa79 [ Tue May 18, 2021 5:22 am ]
Post subject:  Re: Controller Node 7200 blinking amber and blue

sounds broken to me.

I assume if you do a shownode you only see 1 node?

I would log with HPE and get the failed node replaced. you could try reseating the node, but if you're not sure what you doing then i'd leave it for HPE to look at.

There is a console port on the back of the node, could be worth connecting to that, and see if you can see a reason why its not booting up, but to be honest it will probably write so many entries that it wont make much sense.

Author:  Georgii [ Thu Jun 10, 2021 2:52 am ]
Post subject:  Re: Controller Node 7200 blinking amber and blue

Ping me PM. I will help you if your issue not resolved.
Thanks

Author:  xcientist [ Wed May 17, 2023 9:03 am ]
Post subject:  Re: Controller Node 7200 blinking amber and blue

"I am experiencing the same problem; I cannot connect via CLI, and the lights are flashing on and off. I have tried removing and reinserting the node, but the issue remains. Could it be that the SSD disk inside has failed? If I replace it with a new disk of the same capacity, will it work? Do I need to load anything onto it, or should I perform node recovery?"

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/