Hi Team,
I have to 3PAR 7400 2N 3.2.1 MU5 that start to Set up the system to wipe and rerun ootb, but to reboot the node 0 disk failed (Node 1 load OK). Use the Spare Part Node for replace the Node 0, but to make node rescue: Whack>prom edit Board Spin: 04 Size * 256 bytes: 04 Board Class: 920 Board Base: 200040 Board Rev: A8 Assembly Vendor: FXN Assembly Year: 2013 Assembly Week: 47 Assembly Day: 04 Assembly Serial: 00206393 Alternate Class: fff Alternate Base: ffff Alternate Dash: ff System Serial: 0 <---SET SERIAL TO 0 Node ID: 00 <--NODE 0 Midplane Type: 1b <-- 7400 Node Type: 40
Whack>unset sys_serial Whack>ahci init Disk 0: AHCI0: Model: SanDisk PU1000064GBATSSD Serial: 133752400342 Rev: CS.51.00 Capacity: 64.023 GB (125045424 blks) SSD WWN: 5001b44a2fd8 Interface: ATA-9 PIO mode: 0 Queue depth: 31 ECC bytes 0 Write cache ON SMART ON Power saving OFF
Whack>ide erase ide commands unsupported on Sandy Bridge platforms passing command to ahci... Warning!! Security erase can take over an hour Erase all AHCI0 drive data -- Are you sure? (Y/N) Yes Security Status Bits = 0x21 Security Set Password passed Security Erase Prepare passed Enhanced Security Erase supported Performing Enhanced Security Erase Erasing . Security Erase Unit passed Security Status Bits = 0x21
Reset to node but show end:
Booting from device 0, AHCI0Invalid boot sector. Use "boot net install" to correct this.
*** Fatal error: Code 39, sub-code 0x10 (0). AHCI0 MBR does not have a valid partition table Disabled FSBC boot watchdog.
I try to set in the "Whack>" IP add to IP to connect to IP to Node, IP to Server to trasfer TFTP but always failed:
Whack> boot net install Booting from net... TFTP "install" from 10.10.40.36.timeout, failed Disabled FSBC boot watchdog.
That other process can be performed, taking that the other node is ready to start "Out Of The Box Procedure"??
Thk..
|