3PAR Users Group
https://3parug.net/

updatevv
https://3parug.net/viewtopic.php?f=18&t=3267
Page 1 of 1

Author:  squant [ Mon Aug 12, 2019 12:29 pm ]
Post subject:  updatevv

is there a way to determine when the snap volume has been updated? once you execute the command there doesn't seem to be a way to determine when the process ends.

Author:  MammaGutt [ Mon Aug 12, 2019 1:07 pm ]
Post subject:  Re: updatevv

When the snap is updated? It gets updated on every single write to the base volume until it is deleted or another snapshot is triggered.

Author:  squant [ Mon Aug 12, 2019 1:28 pm ]
Post subject:  Re: updatevv

Understood. But I need to know how to determine when the update is complete so I can start the DB backup. The update, DB pause and a few other steps are all being done via scripting.

Author:  MammaGutt [ Mon Aug 12, 2019 2:10 pm ]
Post subject:  Re: updatevv

You should see it in the task list. It usually takes a second.

What type of DB are you using (ie, could RMC be an option)?

Author:  markinnz [ Tue Aug 13, 2019 5:14 pm ]
Post subject:  Re: updatevv

When you run "updatevv" you won't get the command prompt back until the process is complete.
We do about 200 volumes in a set and it can take about 20 seconds to complete.

You can also see the time a snapshot was updated by looking at the output from "showvv -d".

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/