HPE Storage Users Group
https://3parug.net/

Changing the ILO ip address on a Physical SP?
https://3parug.net/viewtopic.php?f=18&t=2897
Page 1 of 1

Author:  Koobster [ Wed Jun 13, 2018 11:15 am ]
Post subject:  Changing the ILO ip address on a Physical SP?

What are the steps to change the ILO Ip address? Cant seem to locate a guide for it

Author:  jbguy [ Wed Jun 13, 2018 3:49 pm ]
Post subject:  Re: Changing the ILO ip address on a Physical SP?

Edit: Nevermind I misunderstood what was being asked.

Author:  koopa79 [ Thu Jun 14, 2018 9:06 am ]
Post subject:  Re: Changing the ILO ip address on a Physical SP?

it depends on the model of server you have. Some of the older SP's didn't an iLO. Some only have a shared port which can do either. to do this you need to configure this in the RBSU which is normally F9 when the server is coming up in POST.
If you have a newer G9 /G10 then you will probably need to configure it in the intelligent provisoning. Once the SP is up, i'm not aware of command line method of setting it. So you may need to reboot the server to set up the iLO. But these methods are the same for a any DL320 / DL360 iLO configuration steps.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/