Hello everyone.
I have a problem with a 3PAR 8400 2 nodes.
node 0 failed.
I bought the same part used on Ebay.
I did the rescue process which is connecting to the new node via serial connection.
Whack>unset sys_serial_10
Whack>unset w19
Whack>ahci init
Whack>ahci erase
Whack>reset
It reboots the controller and when it starts it does not join the cluster.
This is how it ends...
1 17 8086.10d3 17.0.0 MB A 47 95 170 0x17 -> 0xfec01020
Timer Interrupt test: PASS
--> Starting: [10] CPU SDRAM ECC Initialization
--> Starting: [11] Board GPIO Init
--> Starting: [12] Node Fan Test
--> Starting: [14] Power Supply and Battery Init
--> Starting: [15] Power Supply and Battery Test
--> Starting: [16] PROM Checksum Test
PROM checksum: PASS
Invalid Tornado CPU core count - 12 for node type - 0xf0
*** Non-fatal error: Code 25, sub-code 0x5 (0).
Prom Node ID Value and Slot ID mismatch. NodeID: 1 SlotID: 0
Node assembly is in the wrong slot!
*** Fatal error: Code 25, sub-code 0x6 (0).
AHCI0 MBR does not have a valid partition table
Disabled FSBC boot watchdog.
I also did noderescue -node 0 from node 1 but without success.
Note: I am making it start without the 4-port HBA because it appears to be faulty.
any ideas?
Thank you very much as always.
Node assembly is in the wrong slot!
-
- Posts: 24
- Joined: Sun Apr 30, 2017 7:41 pm
Node assembly is in the wrong slot!
- Attachments
-
Log-3PPAR.doc
- (88.5 KiB) Downloaded 1575 times
Re: Node assembly is in the wrong slot!
The views and opinions expressed are my own and do not necessarily reflect those of my current or previous employers.