[3PAR_8200] - Unable to start after power failure [SOLVED]

[Cykani]

Hello,

After a power outtage, our 3PAR 8200 is not starting normally.

I have a 2-nodes controller and 1 disk enclosure.
When the power came back, both power-on simultaneously causing an error on the 3PAR :

InServ cli% showsysmgr
Table of contents (TOC) quorum not reached.

Reason for being unable to automatically start:
Unable to read base TOC from disks to replay powerfail save against

47 disks were available to be examined for TOCs.

I've tried to power off all the system and power on with the good sequence (disk -> nodes), but still the same error.

I've run the command

setsymgr -f tocgen

without success.

Do you have any idea?

Thanks

CN

[Cykani]

Hello,

Finally i've opened a case on HPE Support.

Problem solved.

Thanks

CN